HKS Step 1 Vs Unigroup Cams - Back to Back

Posting up my results from the dyno run with the HKS cams compared to the Unigroup ones. These have my valve springs in them which are uprated.

HKS cams peak power is at 15.5psi and the Unigroup was only at 15psi so probally is the best comparison you could get.

THe HKS Cams the VCT comes on at about 4800rpm - 5000rpm (you can see the little wiggle in the power curve). The Unigroup cams around 6000 - 6200 rpm.

From about 3400rpm to 4000rpm the HKS cams make higher power but the Unigroup cams are higher through the remainder of the rev range.

step 1 hks and the unigroup are custom cams (252 intake 11.5mm, 259 exhaust 11.9mm), both had the same upgraded valve springs.
Both use the std vct gear.

The second graph is where the VCT started to crap itself and for me kind of gives an indication as to if the VCT is worth while or not.

Aiming to get a new VCT gear and tuned on E85 before the track day hopefully but not to promising.