Repairing Holes, Removing Bolts and Pedals

 

After welding up the subframe this morning i started back on the inside and removed the steering coloum and pedals to make it easier to sand and paint behind.

 The old bolt in cage had left 3 bolt holes either side on the floor pan

  so i cut small pieces of metal from one of the brake backing plates i had laying around and layed them over the holes

It was tricky as the metail was thin and i hadn't cleaned it well enough

 Gound it down flat

The other side i was a little better with the welding and was able to lay down some nice beads with the mig.

 

 

I then started to remove some of the excess bolts and tabs from the interior, front passenger footwell had a fair few that i was able to remove